Assigning A Title To A Disc Or Track - Kenwood HM-382MD Instruction Manual

Assigning a title to a disc or track

When titles are assigned to a disc and its tracks,
the titles cannot only be displayed during play-
back but title search (searching a track by the
title) is also made possible. The assigned titles
can be changed or deleted with the same proce-
dure.
Execute operation in stopped condition or during playback.
1
Activate the title input mode.
1 Press the TITLE INPUT key.
2 Select whether the disc title or track
title input.
To return
P.CALL
3 Set the selection.
(To abort operation, press the TITLE INPUT key
again.)
List of registered symbols (ASCII codes):
! " # $ % & '( ) * + , - . / : ; < = > ` ? @ _ ˆ
Total number of title characters
Up to 1792 characters can be input per disc and up
to 80 characters can be input per track.
A space (blank character) also require the same
amount of data as alphanumeric characters. To erase
the title, do not enter a space but delete each char-
acter using the CLEAR/DELETE key.
TITLE
INPUT
To advance
SET
R
Always eject the MD after title entry or editing.
Do not turn power off or apply shock or impact while
"WRITING" is displayed. If the power cord is un-
plugged before "WRITING" disappears, the recorded
or edited data will be lost.
Disc titles can be assigned in stop mode.
When the MD6 key pressed before
step 1-3 while assigning a title to a
track, the title can be entered while lis-
tening to that track.
÷ To cancel title editing in the middle, press the TITLE
INPUT key.
÷ It takes a while because data should be read out of the
disc.
In case of disc title
TITLE INPUT
DISC
In case of track title
Select the desired track No.
TITLE INPUT
0 1 0
MD Edit Functions
......
.......
Continued on next page
51