NEC SL1100 Features And Specifications Manual page 529

ISSUE 2.0
Pro- Program Name/Description
gram
Number
24-09-06 Call Forward Destination for CTX for ALL Call,
No Answer
This is used to set the stations forwarding destina-
tion number if the call originates on a Centrex trunk
(assigned in PRG 14-04). This is for the following
conditions:
1. Call Forward All Calls
2. Call Forward No Answer
24-09-07 Call Forward Destination for CTX for ALL Call,
No Answer
This is used to set the stations forwarding destina-
tion number if the call originates on a Centrex trunk
(assigned in PRG 14-04). This is for the following
condition:
1. Call Forward Busy
20-03-04 Dial Sending Start Time for SLT or ARS
When a Mobile Extension is called the system waits
for this amount of time before dialing the number.
80-03-01 DTMF Detect Level
Used to select the systems DTMF tone detection lev-
els.
With ISDN lines it may be required to set this value
to a setting data of (1) -5 dBm ~ -30 dBm if the user
cannot press the *
14-01-24 Trunk to Trunk Outgoing Caller ID through Mode
This command is for PRI and SIP trunks only and
should never be enabled on any other trunk type.
When this command is enabled the system will pass
the originating callers caller ID on to the Telco if the
call is forwarded out of the system.
Some Telco offices do not support this and will re-
place the number you send them with the main bill-
ing number.
Operation
With any feature, if the Mobile Extension user presses
a second time or the timeout of the inter-digit timer returns the call to conversation mode.
Using Analog Lines with the Mobile Extension
Analog lines can be used for integration with the Mobile Extension using either DILs or VRS Auto
Attendant to access the Mobile Extension Proxy Port. However, it must be noted that the
code must be used prior to terminating any call (e.g., transfer, hang up etc.) as analog trunks do not
provide Disconnect Supervision.
Placing an Intercom Call to a Mobile Extension:
1. Lift the handset or press SPK.
Features and Specifications Manual
key to answer the call.
Assigned Data
Maximum of 24 digits (0 ~ 9, *
R)
@ = Wait for Answer Supervision - ISDN
trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk Only
(default = Not Assigned)
Maximum of 24 digits (0 ~ 9, *
R)
@ = Wait for Answer Supervision - ISDN
trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk Only
(default = Not Assigned)
0 ~ 64800 = 0 ~ 64800 seconds
(default = 3 seconds)
0 = 0 ~ -25 dBm
1 = -5 ~ -30 dBm
2 = -10 ~ -35 dBm
3 = -15 ~ -40 dBm
4 = -20 ~ -45 dBm
5 = -25 ~ -50 dBm
6 = -30 ~ -55 dBm
(default = 0)
0 = Disable (Caller ID not forwarded out.)
1 = Enable (Caller ID is forwarded out.)
(default = 0)
* , an existing call is placed in hold. Pressing
SL1100
Note
, #, @, P,
, #, @, P,
*
*
0 Hang Up
1-517
M