NEC SL1100 Features And Specifications Manual page 145

ISSUE 2.0
Caller ID Refuse for "Private" Numbers
Program
Number
14-01-27 * Caller ID Refuse Setup
Per trunk enable or disable the ability to use the caller ID refuse fea-
ture.
22-18-01 Private Call Assignment Setup - Transfer Mode
Leave this program set to (0) Not Defined to route the Private caller to
a VRS message to refuse the call.
This program can also be used to route the Private caller to an inter-
nal destination (PRG 22-18-02) or a Ring Group (PRG 22-04).
40-10-06 * Set VRS Message for Private Call Refuse
This program specifies the VRS message to be played to the caller
when the Private Call Refuse feature is activated.
If VRS Fixed Message is enabled (PRG 40-10-01), a setting of (101)
will play the following message to the caller: "Your call cannot go
through".
15-07-01 Programmable Function Keys
This program is used on a per station basis to assign different function
keys to the Multiline Terminals.
Function key (86) is the Private Call Refuse key. This key is used to
enable or disable the Private Call Refuse feature. When enabled all
Private numbers received will be routed to the VRS message speci-
fied in PRG 40-10-06.
The feature can be enabled or disabled by using this key or by enter-
ing a service code.
11-10-32 Set Private Call Refuse
This program is used to assign the service code to enable or disable
the Caller ID Refuse feature.
The service code assigned must be within your valid numbering plan
in PRG 11-01-01.
20-07-24 Set/Cancel Private Call Refuse
Per class of service (PRG 20-06-01) this program is used to allow or
deny the stations ability to set or cancel the Private Call Refuse fea-
ture.
The Caller ID - Flexible Ringing Flowchart below helps define programming:
Features and Specifications Manual
Program Name/Description
SL1100
Assigned Data
0 = Disable (CID refuse will not func-
tion.)
1 = Enable
(default = 0)
0 = Not Defined (Private call will not
transfer to a user in the system, can
be routed to VRS message in PRG
40-10-06.)
1 = Internal Dial (Specified in PRG
22-18-02)
2 = Incoming Ring Group (Specified
in PRG 22-04)
(default = 0)
0 = No Message Played
1 ~ 100 = VRS Message 1 ~ 100
101 = VRS Fixed message (Mes-
sage will only play if PRG 40-10-01 is
enabled.)
(default = 0)
86 = Private Call Refuse
(Refer to the programming manual for
the default values and for all other
available options in this command.)
*
Maximum of 8 digits (0 ~ 9, , #)
(default = 646)
0 = Off (User cannot control the fea-
ture.)
1 = On
(default = 1)
1-133
C