Samsung iDCS 500 User Instruction page 8

iDCS 500
TECHNICAL MANUAL
5 = Not Available
6 = EXT
7 = FWD DND
8 = CFU
9 = CFB
✱= CFNR
ACTION
1. Press the transfer key followed by 102
Display shows
Dial 0 – ✱ to select forward type
2.
OR
Press UP or DOWN to select forward type
and press RIGHT soft key to move cursor
3. Dial destination number (e.g., 201)
OR
Press UP or DOWN to select destination
and press RIGHT soft key to move cursor
This option, when set, will forward calls to the external
location programmed as the forward destination after the
External Forward timer in MMC 502 expires. In the M
version of software only CO calls can externally forward.
In the L version there is an option in MMC 210 to allow
intercom calls to forward as well.
This option will forward all calls to the programmed
destination whenever the forwarded station goes into
DND.
This option, when set, will forward all calls to the
programmed destination
destination is in another network node. Available in LE
version software only.
This option, when set, will forward calls to the
programmed destination when the forwarded keyset is
busy, when the programmed destination is in another
network node. Available in LE version software only.
This option, when set, will forward calls to the
programmed destination,
destination is in another network node, if the forwarded
station does not answer a call before the forward no
answer timer in MMC 502 expires Available in LE version
software only.
1.7
USER INSTRUCTIONS
PART 1 NOVEMBER 2001
when the
when the
DISPLAY
[201] FORWARD
0:FORWARD CANCEL
[201] FORWARD
1:ALL CALL:NONE
[201] FORWARD
1:ALL CALL:205
programmed
programmed