Miele G 800 Series Installation Instructions Manual page 33

^ Screw the toekick onto the installed
brackets, with the cutting lines
towards the top, and pull out evenly
and slowly until it aligns with the
toekick of the adjoining cabinets.
The toekick can not be pushed
back in once it has been extended.
It must be unscrewed, so that the
tension on the spring clips can be
released. The brackets can then
be pushed in, and the toekick
reattached.
^ Carefully open the dishwasher door
until it hits the toekick.
^ Using the front lower edge of the
door panel as a guide, draw a line
across the toekick.
^ Unscrew and remove the toekick.
^ If one of the cutting lines is close to
the line just drawn, score the front of
the toekick, and snap off the excess,
otherwise, trim the toekick along the
line using a saw.
^ Screw the toekick back onto the
brackets, with the cut edge at the
bottom.
After installation, carefully open the
dishwasher door to check that the front
panel does not hit the toekick. If it does,
remove the toekick and trim it
accordingly.
Installation
33