Other Problems - JVC SR-VS30U Instructions Manual

Filename [VS30U_4-EN.fm]
VS30U_4-EN.fm Page 80 Thursday, January 31, 2002 3:45 PM
80
EN
TIMER RECORDING (cont.)
SYMPTOM
7. Cable channels are not automatically
switched during timer recording.
8. Satellite channels are not
automatically switched during timer
recording.
9. Timer recording begins as scheduled,
but the channel is always incorrect.

OTHER PROBLEMS

SYMPTOM
1. Whistling or howling is heard from the
TV during camcorder recording.
2. When scanning channels, some of
them are skipped over.
3. The channel cannot be changed.
4. Channel settings that were made
manually seem to have changed or
disappeared.
5. The Remote will not operate your TV
or cable box or DBS receiver.
6. Even though Auto or Semiauto Clock
Set has been performed, the clock is
incorrect.
7. No picture appears when you connect
a device to DV IN/OUT connector.
ATTENTION
This VCR contains microcomputers. External electronic noise or interference can cause microcomputer to malfunction. If the VCR
does not operate correctly switch its power off and unplug the AC power cord from the AC supply. Wait for a while and then plug
the power cord back in. Eject and check the condition of the cassette. If everything appears normal, you can operate the VCR as
usual.
Page 80
POSSIBLE CAUSE
The Controller is not properly
connected to the VCR.
The output channel selected in the
Cable Box Set screen is incorrect.
The cable box is turned off.
The Controller is not properly
connected to the VCR.
The output channel selected in the DBS
Receiver Set screen is incorrect.
The VCR is not set correctly to control
the DBS receiver.
The DBS receiver is turned off.
Even though you do not use an external
cable box or DBS receiver, "CABLE BOX
SET" is set to "ON" or "DBS RECEIVER
SET" is set to "ON".
POSSIBLE CAUSE
The camcorder's microphone is too
close to the TV.
The TV's volume is too high.
Those channels have been designated to
be skipped.
Recording is in progress.
After the manual settings were made,
Auto Channel Set was performed.
The brand codes are set incorrectly.
The clock setting data received from the
host channel is incorrect.
Masterpage:Left
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Connect the Controller correctly
( pg. 20).
After confirming your cable box's output
channel number, re-access the Cable Box
Set screen and select the correct number
( pg. 21).
Make sure the power is on before timer
recording starts.
Connect the Controller correctly
( pg. 23).
After confirming your DBS receiver's
output channel number, re-access the
DBS Receiver Set screen and select the
correct number ( pg. 24).
Set the correct DBS receiver brand code
( pg. 24).
Make sure the power is on before timer
recording starts.
Set "CABLE BOX SET" to "OFF"
( pg. 21) or "DBS RECEIVER SET" is set
to "OFF" ( pg. 24).
CORRECTIVE ACTION
Position the camcorder so its microphone
is away from the TV.
Turn the TV's volume down.
If you need the skipped channels, restore
them ( pg. 19).
Press PAUSE ( ) to pause the recording,
9
change channels, then press PLAY (
resume recording.
Perform manual setting again.
Reset the correct brand codes (
68, or 69).
Select a different host channel during
"Semiauto Clock Set" ( pg. 17), or
perform "Manual Clock Set" (
Turn off the VCR or the connected
appliance once, then turn it on again.
January 31, 2002 3:45 pm
) to
4
pg. 67,
pg. 17).