Remote Control Functions; Remote A/B Code Switching - JVC SR-VS30U Instructions Manual

Filename [VS30U_3-EN.fm]
VS30U_3-EN.fm Page 66 Saturday, February 23, 2002 6:02 PM
66
EN

Remote A/B Code Switching

This Remote is capable of transmitting two control codes; one set
to respond to A code control signals and another set to respond
to B code control signals. This Remote control is preset to send A
code signals because your VCR is initially set to respond to A
code signals. You can easily modify your VCR and the Remote to
respond to B code signals. When using two JVC VCRs, set two
VCRs and their Remotes to different codes, so that you can
operate these VCRs separately.
T
1
4
7
1
Page 66
1 3 2
W
2 3
2
5 6
8 9
0
4
DV S-VHS

REMOTE CONTROL FUNCTIONS

A
Set the remote control code for Remote.
A Press and hold A/B.
B Press the number key "2".
C Press STOP (
), and release A/B.
8
The Remote now can transmit B code control signals.
B
Check the remote control code for VCR.
Press and hold PLAY ( ) on the VCR for more than
4
5 seconds while the VCR is turned off. The code currently
set appears on the display panel.
C
Change the code for VCR.
Press any key on the Remote. The VCR now responds to
B code control signals.
To set the Remote and the VCR back to A code control signals,
repeat the same procedure as shown above except pressing
the number key "1" in step B of 1.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote control
code for the Remote between A and B (
VCRs to different control codes.
To change only the remote control code for the Remote, DO
NOT perform steps 2 and 3.
Masterpage:Left
step 1), keeping two
February 23, 2002 6:02 pm