Table of Contents
Advertisement
Ofrecido por www.electromanuales.com
Gearshift Lever & Shifting
Pattern:
The gearshift lever is mounted on
the centre console between the two
front seats. The gearshift pattern is
shown on the gear lever knob.
NOTICE
The reverse gear should be
engaged only when the vehicle
is
stationary.
Wait
5 seconds after declutching to
ensure smooth engagement of
the reverse gear.
Parking Brake :
1. Parking brake lever
2. Release Button
A. Parking brake Released Condition
B. Parking brake Applied Condition
The mechanical parking brake
which acts only on the rear wheels
is provided on your vehicle. The
parking brake lever is located
behind the gearshift lever. To apply
the parking brake, pull the lever up
for
fully. The indicator light on the
instrument panel will go 'ON'.
To release it, pull the lever up
slightly, press the release button
and push the lever down. The
Xenon At a Glance
GEAR SHIFT LEVER & PARKING BRAKE
parking brake indicator on the
instrument panel will go 'OFF' when
the parking brake lever is fully
released.
Apply the parking brake
properly before leaving the
vehicle & release it before
moving.
Use the parking brake for
holding the vehicle on a down
gradient and put vehicle in
reverse gear.
Use the parking brake for
holding the vehicle on a up
gradient and put vehicle in 1st
gear.
NOTICE
41
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Xenon and is the answer not in the manual?
Questions and answers
Only start with quick start all the time
The TATA Motors Xenon may only start with a quick start due to issues related to the immobilizer, BCM (Body Control Module), or ECU (Engine Control Unit). Possible causes include:
1. Immobilizer and BCM Issues – If the IMMO/BCM and ECU are not correctly coded to the vehicle, the immobilizer may prevent normal starting.
2. ECU/PCM Relay Circuit Fault – The P0685-13 fault code suggests an issue with the ECU/PCM power relay control circuit. Even if the relay shows battery voltage, it may fail under load conditions.
3. Secret Code Immobilizer System – The vehicle may remain in an immobilized state if the correct procedure is not followed to re-enter the secret code.
These factors can cause the vehicle to rely on a quick start rather than a normal ignition sequence.
This answer is automatically generated
I have engine ,anti skid lights on why how to solve