Camera Input/Output Port And Events; I/O Settings - JVC LST0728-001C Instructions Manual

Camera Input/Output Port
and Events
The input/output port is the input/output terminal that is found on
each device registered with this unit. You can register the input port
as [Input events], and the output port as [Outputs...].
A registered input/output port can be linked to an event as
described below. (A Page 102 [Specifying an Output Port])
● Events can be used to start recording, send e-mails, move the
PTZ camera to a preset position, and control the output port of
the device. Events are divided into the four types as described
below.
Input events Registers input signals of sensors connected
to the input port of the device as an [Input
events].
Generic events Registers as a generic event.
VMD events Registers the detected image motion as a
VMD (Video Motion Detection) event.
Event buttons Event generated by buttons that enable
manual operation.

I/O Settings

1
Click the [I/O Setup...] button on the [Camera
Record Setting] screen
● The [I/O Setup] screen appears.
● The [I/O Setup] screen enables you to add input events,
VMD events and outputs that can be used by the network
cameras.
A
B
C
[I/O Setup] Screen
Item
A
Add new
event...
B
Add new
output event...
C
Add VMD
Event(Motion
Detection)
D
Advanced...
E
Remove
selected
F
Edit
selected...
Note :
● The available events differ among network cameras.
● When an event is defined using the [I/O Setup] screen, this
automatically overwrites the alarm settings at the camera. If a
generic event is already in use (when the alarm settings at the
camera are configured manually), the generic event or the event
audio that makes use of the generic event (A Page 129) will be
disabled. However, the generic event settings at the recorder
unit remain unchanged. (VR-N1600U/E)
F
E
D
Description
For specifying input events for the device
selected in the [Defined events] list. You
may be able to specify multiple input
events for some devices.
Click the [+] mark next to the device in the
[Defined events] list, select the preset
input event, and click the [Add new
event...] button to specify a timer event.
(A Page 97)
Displays the [Add new output] screen.
(A Page 98)
For specifying a VMD (Video Motion
Detection) event for the device selected in
the [Defined events] list. Only one VMD
event can be defined for each camera.
Note :
● To avoid the risk of generating an
excessive number of VMD events, a
new VMD event cannot occur within
five seconds after the occurrence of
the last VMD event.
● VMD events cannot be sent by e-mail.
Displays the [Advanced...] screen.
(A Page 98)
For deleting the event selected in the
[Defined events] list.
For editing the event selected in the
[Defined events] list.
95