Adjusting The Output Level Of The Speakers And Subwoofer; Changing The Scanning Mode - JVC AX-THL1 Instructions Manual

Basic operations
Adjusting the output level of
the speakers and subwoofer
1
Press SPK LEVEL to show the
target speaker indication on the
display window.
Each time you press the button, the indication of the
speakers changes as follows:
FRNT L (Front left speaker) Z FRNT R (Front right
speaker) Z CENTER (Center speaker) Z SURR L
(Surround left speaker) Z SURR R (Surround right
speaker) Z SUBWFR (Subwoofer) Z (back to the
beginning)
2
Press +/– to adjust the output
level from –6 to +6 while speaker
indication is displayed.
NOTE
• You can also make adjustments by using the setup menu
shown on the TV screen. (See page 30.)
• The adjustments take effect for all sources.
18
See page 16 for button locations.

Changing the scanning mode

The system can be accommodated to your TV's
scanning mode when playing back a JPEG/
MPEG-1/MPEG-2/ASF file in the USB mass
storage class device.
NOTE
• To use the system in the progressive mode, it is required that
the center unit is connected to the TV by using component
video cord (not supplied). (See page 9.)
7While USB MEMORY playback is stopped
1
Press and hold SCAN MODE for 2
seconds.
The current setting appears on the display window.
2
Press 2/3 to select the desired
mode.
• INT-LACE: Select when your TV supports the
interlaced scanning mode only.
• PROGRESS: Select when your TV equipped with
component jacks terminal supports the progressive
scanning mode.
You can get better picture quality in PROGRESS mode
than in INT-LACE mode.
3
Press ENTER while the selected
mode is displayed.
When "PROGRESS" is selected, the PROGRESSIVE
indicator lights on the display window.
NOTE
• Although the picture may be distorted when you press
ENTER, this is not a malfunction of the system.
• There are some progressive TVs and High-
Definition TVs that are not fully compatible with
this system, resulting in an unnatural picture when
playing back a JPEG/MPEG-1/MPEG-2/ASF file in
the progressive scanning mode. In such a case,
change the scanning mode to "INT-LACE. "
• All JVC progressive TVs and High-Definition TVs
are fully compatible with this system.