EVENT MESSAGE
Jamming restore
K.set : Z=YYY P=X
K.ust : Z=YYY P=X
L.bat rstr WB=XX
LB rstr Z=XXX
Line fault
Line restore
Lost Z=XXX
Low bat rs S=X
Low bat Soundr=X
Low bat Z=XXX
Low bat. WB=XX
Low battery
Masked Z=XXX
Next P.Set :P=X
Next Set :P=X
Next Unset :P=X
No Auxiliary
No Bell
No Comm PO=X
No comm Soundr=X
No comm. GSM
No mask Z=XXX
Omit Box+Bell
Omit Zone=XXX
P.Set :P=X C=YY
P.Set :P=X WB=YY
Panic WB=XX
Police KP=XX
Police main KP
PTM Upload
Radio l.bat S=X
Radio l.bat rs=X
Remote P.Set: P=X
Remote program
Remote Set :P=X
Remote Unset :P=X
Restore Z=XXX
RF Jamming
Set: P=X C=YY
Set: P=X WB=YY
Set fail P=X
Sndr=X Lost Rst
WisDom Installation and Programming Manual
DESCRIPTION
Wireless jamming restore
Partition X is set by key switch defined as Zone YYY
Partition X is unset by key switch defined as Zone YYY
Low battery fault restore from wireless key-fob XX
Low battery restore from wireless Zone No. XXX
If the phone line is cut or the DC level is under 3V
Phone line fault restore
Wireless zone lost, Zone No. XXX
Low battery fault restore from sounder ID=X
Low battery fault from sounder ID=X
Low battery fault from wireless Zone No. XXX
Low battery fault from wireless key-fob XX
System low battery fault from the WisDom
Anti mask fault from zone XXX
Partition X set in Next Part Set mode
Partition X set in Next Set mode
Partition X unset in Next Unset mode
Failure in the system's Aux power
Bell fault
Communication failure with X10 expander ID=X
Communication failure between the WisDom and sounder X
Bus communication failure with the GSM/GPRS module
Anti mask fault restore from zone XXX
Box + Bell tamper is omitted
Zone No. XXX is omitted
Partition X is set in Part Set mode by user YY
Partition X is set in Part Set mode from key-fob YY
Police (panic) alarm from key-fob XX
Police (panic) alarm from wireless keypad XX (keys 1 & 2)
Police (panic) alarm from the WisDom police keys
Load new parameters from PTM accessory
Radio low battery fault
Radio (Transceiver) low battery restore from sounder X
Partition X set in Part Set mode from the UD software
The system has been programmed from the UD software
Partition X set from the UD software
Partition X unset from the UD software
Alarm restore in zone No. XXX
Wireless system jamming
Partition X set by user YY
Partition X set by wireless key-fob YY
Partition X did not complete the setting procedure
The WisDom received a signal from sounder X after it has been
regarded as lost
B-3
Need help?
Do you have a question about the WisDom and is the answer not in the manual?
Questions and answers