Recording Setting - JVC VN-C205 Instructions Manual

Settings (Step 2 Network Settings)
2-4 Other Settings Using the "VN-C205U Setup Tool" (4. Alarm Setting) (Continued)
Other Triggers
Item
5
Motion Detection For setting alarm operations when motion is detected within
the area specified in the motion detection settings.
• Mode * Please refer to the [Alarm 1/2] item for details on the set val-
• Alarm Output ues.
• Message Packet
• Alarm FTP
Alarm Output
Item
6
Output 1/ This section describes the setting procedures for alarm output.
Output 2 Set Values : ON, OFF
Output Value Select the alarm output method.
Output OFF : Output alarm signals when the Alarm Output 1
or Alarm Output 2 terminal is connected to the
GND terminal.
Output ON : Output alarm signals when the Alarm Output 1
or Alarm Output 2 terminal and the GND terminal
are disconnected from each other.
Pattern Level : Continue output of alarm signals throughout the
alarm input process.
Momentum : Output alarm signals only at the specified time.
Specify time using the Return Interval item.
Interval For setting the output interval when the Output Pattern item is
set to Momentum.
This is disabled when the Output Pattern item is set to Level.
7
Output 1 Upon pressing the Output button, alarm signal output will be
force output/ sent from the alarm output terminal on the ceiling mount.
Output 2 This is used for checking the alarm operation.
force output
Note
• Output is disabled when the Output Pattern item is set
to "Level".
44
Function/Set Value
Function/Set Value
2-4 Other Settings Using the "VN-C205U Setup Tool" (5. Recording Setting)
This function is used to perform settings for local recording, which records camera images to
Initial Value
the CF card when the alarm is activated. Please purchase the CF card separately. (
● When an alarm is activated, recording can be performed via "local recording", where camera
—
images are saved into a CF card, or via the V.Networks Controller, where these are saved into the
hard disk of the PC. (
*Please
refer to
1.
Start up the "VN-C205U Setup Tool" and select [Recording]. To make new values
the [Alarm
effective, click on [Apply], followed by [OK].
1/2] item
for the
● Setting the [Trigger Recording] screen
initial
values.
Initial Value
OFF
—
—
—
—
☞
Page 67)
Select alarm input signal "Trigger" for starting local
recording.
☞
Page 19)
45