Table of Contents
Advertisement
Settings (Step 2 Setting the Network)
2-4 Other Settings with V.Networks Setup Tool [3. Recording Setting]
This function records the image to the memory of VN-C655 when an alarm is activated.
• When an alarm is activated, image recording can be carried out in one of the following two ways.
One way, local recording, saves images to the VN-C655 memory, and the other record images with
[V.Networks Controller] and saves them to the PC hard disc drive, etc. (
1.
Start up [V.Networks Setup Tool] and select [Recording].
To make new values effective, press [Apply] and then
Trigger Recording
2.
Frame Rate
38
For selecting the record starting trigger, the
alarm input signal to start local recording.
For setting the frame rate for local recording,
select [Change the Recording FrameRate during
trigger recording] and set the frame rate (30,
15, 10, 8, 7, 6, 5, 4, 3, 2 or 1). The default value
is 30 fps.
For setting the recording time. Up to 60 seconds
can be set both before and after an alarm input.
Caution
● If the value for before a trigger is set to "0,"
set a different value for after the trigger. Both
values cannot be set to "0" at the same time.
● Because of the memory capacity of VN-
C655, the setting times before and after a
trigger and the actual maximum recording
time are not the same.
Example:
• If 320x240 (15 fps)/640x480 (5 fps) with a
compression rate of 2, the actual recording
time is 5 to 0 and 30 to 35 seconds, before
and after a trigger respectively.
☞
Page 64)
.
Advertisement
Table of Contents
