Connect To Controlling Device - GE Series 2000 Installation Instructions Manual

Connector Locations
8
The following illustration describes the various input connectors on the rear
panel of the treadmill.
ON/OFF Power Switch
WARNING
INJURY TO PERSON — Keep hands, hair, jewelry, and
loose clothing away from moving parts. Do not place feet
under treadmill during elevation changes. Otherwise,
serious injury could result.
1. Attach the appropriate controller cable from the stress system or MTC-1 and
the AC power cable. Use the supplied interface cable to connect the Series
2000 treadmill to the host (i.e., CASE, MTC-1).
Series 2000 Treadmill
F1 0.5ASB
250V
F2 0.5ASB
250V
WARNING: FOR CONTINUED
PROTECTION AGAINST RISK OF
FIRE REPLACE ONLY WITH FUSE
OF SAME TYPE AND RATING.
CAUTION: ELECTRICAL SHOCK HAZARD.
DO NOT REMOVE COVER. REFER
SERVICING TO QUALIFIED PERSONNEL.
CAUTION: DO NOT USE BOTH
CONNECTORS AT THE SAME TIME.
RS 232 Serial Port
RS-232
SERIAL CONT
RS 422 Serial Port
RS-422
SERIAL CONT
Emergency Stop
STOP
Switch Connection
Service Port
Equipotential
(ground lug)
AC Power Connection
(200-240V, 50-60Hz,
16A)
220-240V~ 50-60Hz 16A
006
2021403-028A