Setting The Timer For Energy-Saving Standby Mode - Melitta Caffeo Solo Operating Instructions Manual
Fully automatic coffeemaker
Hide thumbs
Also See for Caffeo Solo:
- Operating instructions manual (247 pages) ,
- Operating instruction (215 pages) ,
- Operating instructions manual (14 pages)
Table of Contents
Advertisement
•
Press the On / Off button
hardness.
→
All symbols in the display flash briefly for confirmation. The appliance is
ready for operation, the standby symbol
Note
During the adjusting process, if you do not press a button within 60 se-
conds the appliance automatically reverts to standby mode.
Setting the timer for energysaving standby mode
Additional information on energy-saving standby mode is provided on page 52. the
timer is factory-set to level 1 (15 minutes).
Prerequisite: The appliance is ready for operation, the standby symbol
is illuminated.
Adjust the timer as follows:
•
simultaneously press the button for single-cup dispensing
button for two-cup dispensing
→
the standby symbol
•
Press the button for single-cup dispensing
adjusting water hardness.
→
the symbol for the water reservoir
•
Press the brewing strength button several times
possible times for the timer.
to confirm the selected degree of water
is illuminated.
for more than 2 seconds.
is flashing rapidly.
is illuminated.
and the
twice to call the menu for
to select from four
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Caffeo Solo and is the answer not in the manual?
Questions and answers
I have insert brewing unit error
To fix the "insert brewing unit" error on a Melitta Caffeo Solo:
1. Ensure the brewing unit is correctly inserted and locked in place.
2. If the buttons for single and two-cup operation flash alternately with the On/Off button:
- The brewing unit may be missing or not properly inserted.
- Insert the brewing unit properly.
3. If the brewing chamber is overfilled:
- Switch off the appliance.
- Switch it on again via the On/Off button.
- Repeat if necessary until standby mode is displayed.
4. If all buttons flash continuously (system error):
- Switch off the appliance.
- Switch it on again via the On/Off button.
- If the problem persists, send the appliance to the service organization.
This answer is automatically generated