Inserting The Melitta Claris ® Water Filter - Melitta Caffeo Solo Operating Instructions Manual

 Inserting the Melitta Claris
A Melitta claris water filter for filtering out lime scale is included with the appliance.
®
After starting up the appliance for the first time, please insert the water filter into
the appliance. If you use the filter, you will decalcify the appliance less frequently
and the water hardness will be set on hardness level 1 automatically (see page 53 in
this regard). the service life of your machine will be extended thanks to the reliable
protection against lime scale. The water filter should be changed regularly (every 2
months), at the latest however it must be changed when the symbol for the water filter
is shown in the display.
Prerequisite: The appliance is switched off.
•
simultaneously press the button for brewing strength
button for more than 2 seconds.
→ The symbol for the water filter
the symbol for the drip tray
•
empty the drip tray and then reinsert it.
→
the symbol for the water reservoir
• Flip up the cover of the water reservoir and pull the water reservoir up
and out of the device.
• empty the water reservoir.
•
screw the Melitta claris
water reservoir.
•
Fill the water reservoir with fresh water to the Max. mark and reinsert it in
the appliance.
• Press the button for brewing strength
→ The device will execute an automatic filter rinsing process; hot water in the
interior of the appliance flows into the drip tray. Subsequently the standby
symbol and the bean symbols
the device is ready for operation and water hardness is automatically set to
hardness level 1.
•
empty the drip tray and then reinsert it.
®
flashes during the entire change procedure.
is illuminated.
is illuminated.
water filter into the thread on the floor of the
®
.
are illuminated.
water filter
and the on / off