Installation - Miele CVA 5065 User Manual

Installation

Installation
Before installation make sure that
there is no power supply to the
machine. This also applies should it
ever need to be taken out of its
housing unit.
The machine may only be used
when it has been built in. It can only
be used in areas with an ambient
temperature of +15 °C to +60 °C.
You will need two Allen keys (size 3
and 5) for installing the machine.
^ Using the large allen key, unscrew all
four feet out by about 2 mm.
^ Push the machine all the way into the
niche until there is a resistance. Then
check the height to make sure it is
sitting centrally in the unit and that it
is level.
If this is not the case, realign the 4
feet underneath the machine using
the large allen key.
The feet can be unscrewed by up to
approx. 10 mm.
76
^ If the furniture unit walls are 19 mm
thick you will need to drill four holes
in the sides for securing the machine.
To mark the position of these holes:
– Align the machine in the niche.
Screw the side socket screws inside
the machine in a little so that they
make indents in the side walls, and
then unscrew them again.
– Take the machine out of the niche
and drill ø 4.5 mm holes, 2 mm deep
where you made the indentations.
^ Plumb the appliance into the mains
water supply.
^ Connect the appliance to the
electricity supply.
^ Push it all the way into the niche until
you feel resistance.
^ Open the machine door, and partially
tighten the side socket screws.
^ Carefully turn the lower socket
screws a to centre the machine in
the niche.
^ Tighten both upper socket screws b
by hand to secure the machine in the
unit. Do not overtighten them.