Installation; Fresh Water Connection - Miele CVA7845CST Operating And Installation Instructions

Fresh water connection


Risk of injury and appliance
damage if appliance is not
connected properly.
Failing to connect the appliance
properly can result in personal injury
and / or material damage.
The appliance may only be
connected to the fresh water
connection by qualified specialists.

Risk to health and risk of
damage due to contaminated water.
The quality of the incoming water
must conform to the requirements for
drinking water in the country where
the coffee machine is being used.
Connect the coffee machine to the
drinking water supply.
Connection to the water supply must
comply with the applicable
regulations in the country where the
appliance is being installed. All
appliances and systems used to
supply water to the coffee machine
must also comply with the applicable
regulations in the respective country.
Connect the coffee machine directly
to a fresh water pipe.
Avoid connecting the coffee machine
to a water inlet in which the water
might stagnate. Otherwise, the
flavour of the drinks could be
impaired.
The coffee machine meets the
requirements of IEC 61770 and
EN 61770.
The coffee machine may only be
connected to a cold water supply.
The water connection pressure needs
to be between 100 and 1,000 kPa
(1 and 10 bar).
A faucet must be provided between the
stainless steel hose and the domestic
water supply to ensure that the water
supply can be cut off if necessary.
Make sure the faucet remains easily
accessible once the coffee machine has
been installed.
Connecting the stainless steel hose
to the coffee machine
Only use the stainless steel hose
supplied. The stainless steel hose
must not be shortened, extended, or
replaced by a different hose.
The stainless steel hose must only
be replaced by an original Miele part.
The food-grade, stainless steel hose
is available to order from the Miele
online shop, from Miele Service, or
from your local Miele dealer.
The stainless steel hose supplied is
1.5 m long.
 Remove the cover cap from the fresh
water connection at the back of the
coffee machine.
 Take the angled end of the stainless
steel hose and check whether there is
a sealing ring. Install one if necessary.
 Screw the stainless steel hose
coupling nut onto the thread.
 Ensure that it is screwed into position
correctly and watertight.

Installation

107