Advertisement
ö
Trimming the toeckick
The rear of the toekick has two cutting
lines.
Screw the toekick onto the brackets,
with the cutting lines toward the top,
and pull out evenly until it aligns with
the toekick of the adjoining cabinets.
The toekick cannot be pushed back
in. It must be unscrewed, so that the
tension on the spring clips can be re-
leased. The brackets can then be
pushed in, and the toekick re-at-
tached.
24
Carefully open the dishwasher door
until it hits the toekick.
Using the front lower edge of the
door panel as a guide, draw a line
across the toekick.
Unscrew and remove the toekick.
If one of the cutting lines is close to
the line just drawn, score the front of
the toekick and snap off the excess,
or trim the toekick along the line
using a saw.
Screw the toekick back onto the
brackets, with the cut edge at the
bottom.
If the dishwasher door does not open
completely, the toekick may need fur-
ther trimming.
Advertisement
