Advertisement
Situation C - Changing the color of,
and shortening the decor insert:
Remove the decor strips, decor insert,
backing panel and polystyrene
spacers. Replace the existing insert
with the one that was cut to the
dimensions calculated in Step 5. If
the new decor insert is thicker than
1/16" (2 mm), the cardboard spacer
can be removed. (The maximum
thickness of any panel cannot ex-
ceed 5/32" (4 mm).)
Re-installation:
Re-install the front panel by revers-
ing the procedures outlined in Step 6
and Step 4.
Push the dishwasher back under the
countertop and proceed to Step 7,
"Adjusting the door springs."
Step 7.
Adjusting the door springs
The door springs are correctly adjusted
when a half opened door remains in
that position when released.
If the door drops down, the springs
need to be tightened.
If the door closes, the springs need to
be loosened.
The adjusting screw is located in the
upper front strip on the left hand side of
the dishwasher.
Open the dishwasher door.
Adjust the door springs to the cor-
rect balance by using a Torx screw-
driver:
– turn clockwise to tighten
– turn counterclockwise to loosen.
ö
21
Advertisement
