Toshiba Strata CTX Programming Manual page 219

Follow these steps to program Network BLF and
Local
(CTX670-1)
Program 916 - Set
IP Address = 192.168.1.44
Program 803 - Log. Device
= 400 (BLF), Port 11
Progra 801 - BLF Server
Port = 6000
Program 670 - 00 LAN
Port = 11
Strata Net
Node ID: 16
LAN / Switch / Hub
Example Procedure to Assign Network BLF for Node 16
1. Program 916 assigns IP Addresses.
2. Program 803 assigns Network BLF (400) and Port 11.
3. Program 801 assigns BLF Server Port 6000.
4. Program 651~656 and 102 assign Strata Net Node IDs and network (QSIG).
5. Program 670 assigns Remote Nodes (17, 18) and their BLF Server Ports.
6. Repeat steps 1~5 for nodes 17 and 18. Note: Steps 4 and 5 assign parameters for Remote Nodes only
Figure 9-3 Network BLF Example
From WinAdmin
Step 1:
Perform the all of the following steps on the local CTX first, then repeat them on each of the remote CTXs.
1. Set up the IP address of the local CTX (with the active CTX Attendant) using Program
Configuration" on page
2. From the Program menu, select Services > Networking > Node ID to set the Primary Node ID. Refer to
"656 Node ID Assignment"
3. From the Program menu, select System > I/O Device. Refer to Program
Assignments" on page
4. Enter IO Logical Device values:
• 00 Logical Device No. = 400
• 01 Device Connection = LAN
• 02 Device Port No. = 11
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
Figure
Remote
(CTX670-2)
Program 916 - Set IP
Address = 192.168.1.43
Program 803 - Log. Device
= 400 (BLF), Port 11
Program 801 - BLF Server
Port = 6000
Program 670 - 00 LAN
Port = 11
Program 670
QSIG Remote Node ID: 17
IP-Network
LAN / Switch / Hub
10-14.
on page 9-39.
4-27.
9-3:
Program 916 - Set IP
Address = 192.168.1.53
Program 803 - Log. Device
= 400 (BLF), Port 11
Program 801 - BLF Server
Port = 6000
Program 670 - 00 LAN
Port = 11
QSIG
IP-Network
"803 SMDR SMDI CTI Port
Services
Networking
Remote
(CTX100)
Program 670
Remote Node ID: 18
LAN / Switch / Hub
6701
.
"916 IP
9-33