Troubleshooting - Bruno SRE-1550 Electra-Ride II Installation Manual
Stairway elevator
Hide thumbs
Also See for SRE-1550 Electra-Ride II:
- Operator's manual (24 pages) ,
- Installation manual (44 pages)
Table of Contents
Advertisement
UNIT FAILS TO
OPERATE
UNIT OPERATES
SLOWLY, LACKS
POWER
CONTROLS OPERATE BACK-
WARDS AND UNIT GOES
"UP" SLOWLY AND "DOWN"
FAST
SRE-1550 UL 06-18-2004
Check circuit breaker. Reset if necessary.
Check battery connections.
Check footrest safety switches to see if one of these limit
switches is depressed. Sliding safety tray below footrest
should slide freely and should not stick in a position which
would
depress one of the safety switches.
Check for discharged batteries. Battery voltage should be in a
range of 16-28 VDC.
Commercial units only: Check fuse. Replace if necessary.
Check for discharged batteries.
Check setting of speed control potentiometer.
Check for loose connections.
Check to make sure charger is plugged in and working.
Unit has been connected for left-hand operation but is
installed on the right-hand side of the stairs (or vice versa).
Make correct connections according to instructions in the
installation manual, section on Reversing Operations.
51
TROUBLESHOOTING
©2004,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the SRE-1550 Electra-Ride II and is the answer not in the manual?
Questions and answers
Do you cut the rail to the specific length I provide you or do I adjust the rail to the length of the stairs? Is the rail shipped in multiple sections to be assembled on site?
The Bruno SRE-1550 Electra-Ride II rail is adjusted to the length of the stairs by measuring along a straight line placed on the stairs and adding a specific measurement to custom fit the installation. The rail is shipped in multiple 8-foot sections that are cut and assembled on-site to fit the stairway.
This answer is automatically generated