Table of Contents
Advertisement
BURLEY G4240 – 49 MODEL
FLUELESS GAS HEATER
INSTALLATION, SERVICING
& USER INSTRUCTIONS
FOR USE IN THE COUNTRIES STATED ON THE DATA PLATE AND CARTON
WITH NATURAL GAS G20
OR LPG PROPANE GAS G31
(REFER TO RATING LABEL)
For the following countries: GB, IE
EVEN IF YOU HAVE FITTED THESE FIRES BEFORE,
PLEASE FOLLOW THESE INSTRUCTIONS STEP BY STEP.
Legislation and regulations do change over time!
LEAVE THESE INSTRUCTIONS WITH THE USER
TO OBTAIN YOUR FIRST YEAR GUARANTEE, THE INSTALLER AND CUSTOMER
MUST FILL IN THE SEPARATE GUARANTEE AND RETURN IT TO
BURLEY WITIHIN 7 DAYS OF FITTING.
A FREE SECOND YEAR GUARANTEE IS OFFERED SUBJECT TO THE FIRE BEING SERVICED
BY A CORGI ENGINEER DURING THE FIRST YEAR OF OWNERSHIP.
PROOF OF SERVICING MUST BE RETAINED
FAILURE TO HAVE THIS APPLIANCE FITTED BY A CORGI REGISTERED
FITTER INVALIDATES THE WARRANTY
Burley Appliances Ltd,
Lands End Way, Oakham, Rutland, LE15 6RB
Telephone: +44 (0)1572 756956 Fax: +44 (0)1572 724390
e-mail:
info@burley.co.uk
web:
www.burley.co.uk
G4240InstUser
G20/31
Issue Sept08 – v.4
Advertisement
Table of Contents
Related Manuals for Burley G4240
Summary of Contents for Burley G4240
-
Page 1: User Instructions
BURLEY G4240 – 49 MODEL FLUELESS GAS HEATER INSTALLATION, SERVICING & USER INSTRUCTIONS FOR USE IN THE COUNTRIES STATED ON THE DATA PLATE AND CARTON WITH NATURAL GAS G20 OR LPG PROPANE GAS G31 (REFER TO RATING LABEL) For the following countries: GB, IE EVEN IF YOU HAVE FITTED THESE FIRES BEFORE, PLEASE FOLLOW THESE INSTRUCTIONS STEP BY STEP. - Page 2 INTRODUCTION Thank you for choosing this burley product. All of our products carry a CE mark which is awarded by an independent test house (notified body) and shows the fires have been type tested to meet the essential requirements of the European Gas Appliance Directive and the appropriate British Standards.
- Page 3 BS5871 pt4 except where Burley instruction state differently. For the Republic of Ireland, reference should be made to IS813 and ICP3 and any guidance notes from Bord Gais.
- Page 4 Note: Burley manufacture purpose made surrounds, which have been specially tested with the appliance for compatibility. (This includes the wooden hearth) If a Burley Surround is used then the fires must be installed as supplied with the 60mm spacer fitted.
- Page 5 The hearth and back panel must be made from a non-combustible material although ‘lightweight’ and tiled surrounds can be used provided they have a minimum heat rating of 150oc. Consideration should be given to the effect of expansion and contraction caused by temperature and back panels should be allowed to float or attached with a flexible mastic on the extreme edges.
- Page 6 PREPARING THE APPLIANCE Unpack the heater (see 2.0). Ensure appliance is correctly marked for the gas it is to be used with. Take the appliance components and lay them out in an ordered manner. To prevent damage the decorative frame, fret, coals and ceramic fire bed components can be placed safely to one side.
- Page 7 THE PILOT. BURLEY APPLIANCES IS THE ONLY COMPANY TO BENCH RUN AND THOROUGHLY TEST EVERY SINGLE GAS FIRE IT PRODUCES. BURLEY IS IN THE UNIQUE POSITION OF KNOWING THAT EVERY APPLIANCE LEAVES THE FACTORY IN PERFECT WORKING ORDER. There are 2 control knobs on the appliance. The left hand one (coloured black) controls On / Off and High / Low flame.
- Page 8 10.3 If you have any questions or the fire is not operating correctly, phone the Burley help- line BEFORE you leave the installation. If the appliance is not fitted in strict accordance with these instructions, Burley cannot be held responsible for any damage caused and reserve the right to charge for any corrective work.
- Page 9 minutes, please advise the customer of this. If any part of the OXY Pilot is damaged the entire unit must be replaced. Do not attempt to bend or alter the flame head, thermocouple or aeration hole. Use only genuine spare parts as similar looking parts from other appliances may well give different or inferior performance and could lead to a hazard.
- Page 10 Burley Appliances are the only company to bench run and thoroughly test every single Flueless gas fire it produces. Burley is in the unique position of knowing that every appliance leaves the factory in perfect working order.
-
Page 11: Installation Instructions
Replacement rechargeable batteries for the fire and replacement handsets are available from Burley Appliances on 01572 756956 or through your retailer. The 9 volt handset battery is available from normal retail outlets. Please note that the cost is not covered by the guarantee. - Page 12 The fire is fitted with a special 7.2volt rechargeable battery available from your retailer or from Burley Appliances on 01572 756956. It can be changed by simply sliding it out of its housing under the fire, undoing the connector block and carefully replacing with a new one We regret that the warranty does not cover items such as batteries.
- Page 13 Flue Gas Analysers – Installation & Servicing Facts • Please read this sheet even if you have fitted our fires before. • Please leave this sheet with the customer as reference for future servicing of the appliance. • Please explain to the customer how the fire works and the details and facts listed on this sheet, particularly what the catalyst does and doesn’t do.
- Page 14 After the equivalent of 30 years of use, the catalytic converter is as efficient as it was when brand new. Burley manages to achieve this by designing the fire to ensure that the catalytic converter is in exactly the right position for long life and maximum efficiency.
- Page 15 Gas rating of Burley Fluless Appliances Burley’s Flueless Gas Appliances are all gas input rated in the factory and undergo further line tests for combustion, sooting and visual performance. For Installers who wish to gas input rate appliances we need to establish tolerances for pass and fail.
- Page 16 The appliance has been used solely in accordance with the instruction book. • Any in guarantee work carried out by Burley Appliances will be charged for if the fault is caused by incorrect pressure or gas, incorrect installation, operator error, neglect or abuse.
Need help?
Do you have a question about the G4240 and is the answer not in the manual?
Questions and answers
Readings for combustion test