Table of Contents
Advertisement
MAINTENANCE
Every 100 Hours
Cleaning the Water Separator
WARNING
¡ ¡ ¡ ¡ ¡ Do not smoke or permit open flames
while handling fuel or working on the
fuel system.
¡ ¡ ¡ ¡ ¡ Stop the engine in a well-ventilated
place and allow it to cool down before
performing maintenance.
¡ ¡ ¡ ¡ ¡ Clean up spilled fuel immediately.
S : Closed
1. Open the front cover.
2. Close the lever (2).
3. Loosen the ring (3), then remove the case
(4), element (5) and indicator ring (6) and
clean them.
4. Inspect the O-ring, and if there are any
scratches or other irregularities, replace
it.
5. Assemble the indicator ring (6), case (4)
and element (5) and tighten the ring (3).
6. Open the lever (2) and bleed the air.
Refer to page 139 "Bleeding the Air from
the Fuel System".
2
8
1
ON
S
OFF
3
5
4
6
7
K3G002
115
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the TB125 and is the answer not in the manual?
Questions and answers
Takeuchi tb125 2006reg starts runs then cuts out after 10seconds ,water light flashes turn off ignition and starts running again every time
A 2006 Takeuchi TB125 starting, running for 10 seconds, and then cutting out with the water light flashing could indicate water contamination in the fuel system. Possible causes include:
- Water in the fuel filter or fuel system: Drain the water separator and replace the fuel filter if necessary.
- Clogged fuel system: Air or debris in the fuel system can cause engine issues. Bleed the air from the fuel system.
- Faulty water sensor: If the sensor is malfunctioning, it may incorrectly trigger the warning light and shut down the engine.
Check and drain the fuel system, replace filters if needed, and inspect the water sensor. If the issue persists, consult a Takeuchi service outlet.
This answer is automatically generated
does the taheuchi digger have alarm buzzers
What is a decel light for
The decel light on a Takeuchi TB125 lights up when the engine coolant temperature rises abnormally while the engine speed decreases. It serves as a warning to indicate potential overheating during deceleration.
This answer is automatically generated