Table of Contents
Advertisement
OPTIONS
Immobilizer System
Re-Registration of the Keys
Re-register the keys in the following cases:
¡ If one of the immobilizer keys is lost, re-
register the remaining keys so as to
prevent theft.
¡ If you purchase new immobilizer keys,
they must be registered before they can
be used with the machine's immobilizer
system.
¡ The ID code is changed each time a key
is registered, so any keys you already
have must also be re-register.
Refer to page 252 "Immobilizer System".
IMPORTANT: Please read and understand
the registration procedure before starting.
If you stop in the middle, you may have to
start over from the beginning.
Do not turn the key to the START (
position while performing the steps 3 to
12.
Registration Procedure
Immobilizer key
1. Prepare the immobilizer keys you wish to
register (key grip: black/maximum of 5
keys) and the registration key (key grip:
gray).
2. Check whether or not the engine starts
with the registration key.
If the engine does not start, it is possible
that the registration key belongs to another
product.
This matter must be checked again.
)
Registration key
3. Insert the registration key into the starter
switch and turn it from the OFF (O) position
to the ON ( I ) position.
4. Hold for about 10 seconds.
254
Registration key
N0B026E
N0B029E
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the TB125 and is the answer not in the manual?
Questions and answers
Takeuchi tb125 2006reg starts runs then cuts out after 10seconds ,water light flashes turn off ignition and starts running again every time
A 2006 Takeuchi TB125 starting, running for 10 seconds, and then cutting out with the water light flashing could indicate water contamination in the fuel system. Possible causes include:
- Water in the fuel filter or fuel system: Drain the water separator and replace the fuel filter if necessary.
- Clogged fuel system: Air or debris in the fuel system can cause engine issues. Bleed the air from the fuel system.
- Faulty water sensor: If the sensor is malfunctioning, it may incorrectly trigger the warning light and shut down the engine.
Check and drain the fuel system, replace filters if needed, and inspect the water sensor. If the issue persists, consult a Takeuchi service outlet.
This answer is automatically generated
does the taheuchi digger have alarm buzzers
What is a decel light for
The decel light on a Takeuchi TB125 lights up when the engine coolant temperature rises abnormally while the engine speed decreases. It serves as a warning to indicate potential overheating during deceleration.
This answer is automatically generated