Advertisement
Installing the Headlight
Extension Bar
If your snowthrower has a headlight, you will need to
move the headlight.
1. Loosen the nuts that hold the headlight bracket onto
the right side of the handle (Fig. 9).
2
m-7011
Figure 9
1. Headlight
2. Bracket
2. Rotate the headlight bracket to the right 90 degrees
(Fig. 9) and tighten the nuts.
3. Install the headlight extension bar with a bolt (5/16 x
3/4 in.) and a flange locknut (5/16 in.) and secure the
headlight to the bar.
Figure 10
1. Headlight extension bar
(shown with cover)
1
3
3. Nut (2)
1
m-7253
Installing the Cover
1. Open the 2 slits in the cover to allow room for the
chute control rod and the headlight extension bar.
2. Slip the cover over the frame assembly and close the
snaps to secure the cover around the top and rear
frames (Fig. 11).
1
2
4
Figure 11
1. Top flap
2. Rear frame
3. Close the slits around the chute control bar and
headlight extension bar.
Note: The front of the snow cab should be slightly
forward from vertical when the snowthrower is not in use
(Fig. 12).
Figure 12
1. Cover
4
3
m-2697
3. Top frame
4. Side flap
m-7253
Advertisement
