Toro 107-3814 Installation Instructions

Snow Cab Kit
Power Max
Model No. 107-3814
Save these instructions with your Operator's Manual for
future reference.
Warning
Installing this snow cab onto a Power Max
snowthrower without properly installing a
counterweight to the front of the snowthrower can
cause it to tip backward and fall on the operator,
causing injury.
Do not operate a snowthrower with a snow cab
that does not have the proper counterweight.
Obtain and install a Toro weight kit to the front
of the snowthrower in order to balance the
added weight of the snow cab.
Contents of the Kit
DESCRIPTION
U-brackets
Washers
End caps
Headlight extension bar
Bolts, 1/4 x 1 in.
Bolts, 1/4 x 3/4 in.
Bolts, 1/4 x 1-3/4 in.
Locknuts, 1/4 in.
Bolt, 5/16 x 3/4 in.
Flange locknut, 5/16 in.
Top frame
Rear frame
Horizontal frame
Left mounting bracket
Right mounting bracket
Front posts
Cover
2003—The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
Snowthrowers
Installing the Snow Cab Frame
on the Snowthrower
1. Remove the 2 upper handle nuts (1 on each side) from
the snowthrower handle assembly (Fig. 1) and save
them for step 2.
QUANTITY
2
4
2
1
2
6
1. Handle assembly
2. Upper handle nut (2)
2
3. U-bracket (2)
10
2. Install the lower front end of the left and right
mounting brackets onto the handle assembly using the
1
upper handle mounting nuts you removed in step 1
1
(Fig. 1).
1
3. Install the other lower end of each mounting bracket
onto the handle assembly with a U-bracket, bolt (1/4 x
1
1-3/4 in.), and locknut (Fig. 1).
1
Note: You may need to squeeze each U-bracket together
1
slightly before installing it onto the handle assembly.
1
Note: The ends of the U-brackets should face downward.
2
1
Printed in the USA
All Rights Reserved
Form No. 3351-212
Installation Instructions
6
4
3
1
2
Figure 1
4. Bolt, 1/4 x 1-3/4 in. (2)
5. Locknut (2)
6. Left mounting bracket
Original Instructions (EN)
5
m-7249