2.1.2 Accessing the Web User Interface
Note
•
You may need to enter a system password to access this menu.
6.
Press
to display the second screen, select "Enable CS Web", and then press
7.
When the operation is complete, the following screen is displayed.
Note
•
You can access the Web with a fixed IP address without a registered S-PS by following the procedure
below.
1.
Turn on SIP-CS by holding the RESET switch.
2.
After the LED flashes red, amber and green alternately, release the RESET switch.
The default IP address and subnet mask are as follows:
–
IP address: 192.168.0.241
–
Subnet mask: 255.255.255.0
•
When accessing the Web with a fixed IP address, the VLAN feature will be turned off.
2.1.2 Accessing the Web User Interface
The SIP-CS can be configured from the Web user interface.
To access the Web user interface
1.
Determine the Master CS's IP address.
If the Master CS's IP address is already known, skip this step and proceed to step 2.
a.
Enter the "Setting Handset" menu on your S-PS (® see Opening the Web Port).
b.
Select "Other Option" and then press
c.
Select "MasterCS Address" and then press
24
Administrator Guide
.
.
.
Document Version 2013-03