Panasonic KX-UDS124 Administrator's Manual page 130

2.6.8 Tone Settings
Tone Timings
Description
Value Range
Default Value
2.6.8.2 Busy Tone
Tone Frequencies
Description
Value Range
Default Value
Tone Timings
Description
Value Range
Default Value
130 Administrator Guide
Specifies the pattern, in milliseconds, of dial tones using up to 10 whole
numbers (off 1, on 1, off 2, on 2...) separated by commas.
Note
•
The SIP-CS will not play the tone for the duration of the first
value, play it for the duration of the second value, stop it for the
duration of the third value, play it again for the duration of the
fourth value, and so on. The whole sequence will then repeat.
For example, if the value for this setting is "100,100,100,0", the
SIP-CS will not play the tone for 100 ms, play it for 100 ms, stop
it for 100 ms, and then play it continuously.
•
It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
•
Avoid setting 1–50 for any of the values.
0–16000 (0: Infinite time)
60,0
Specifies the dual-tone frequencies, in hertz, of busy tones using 2
whole numbers separated by a comma.
0, 200–2000 (0: No tone)
480,620
Specifies the pattern, in milliseconds, of busy tones using up to 10
whole numbers (off 1, on 1, off 2, on 2...) separated by commas.
Note
•
It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
•
Avoid setting 1–50 for any of the values.
0–16000 (0: Infinite time)
60,500,440
Document Version 2013-03