Measuring At One Listening Position (Single Measure) - Yamaha Aventage RX-A3040 Owner's Manual

1 2 3 4 5 6 7 8 9 10
Cursor keys
ENTER
RETURN
Measuring at one listening position
(single measure)
When "Multi Position" is set to "No", follow the procedure below for
measurement. It takes about 5 minutes to perform the
measurement.
• If any error message (such as E-1) or warning message (such as W-1) appears,
see "Error messages" (p.57) or "Warning messages" (p.58).
• (RX-A3040 only)
Do not use the microphone base until the corresponding message appear on the
TV.
1
To start the measurement, use the cursor keys to
select "Measure" and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
• To cancel the measurement temporarily, press RETURN.
The following screen appears on the TV when the
measurement finishes.
(RX-A2040)
(RX-A3040 [when angle/height measurement is disabled])
Proceed to Step 3.
(RX-A3040 [when angle/height measurement is enabled])
Proceed to Step 2.
2
Perform the angle/height measurement.
a Use the cursor keys to select "YES" and press ENTER.
Select "NO" to cancel the angle/height measurement.
b Attach the supplied pole to the center of the microphone base.
Pole
Microphone base
PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO)
50
En