Add Remote To Panel - Advanced - IDS X64 Installer Manual

Section: 2
Remote Receiver 4 is indicated by zone LED 3 coming on.
11. Enter [USER CODE] followed by the [*] key.
12. The READY and POWER LEDs flash simultaneously, and the ARM and AWAY LEDs are on.
13. Press the [*] key to proceed, or the [#] key to abort.
14. Press and hold the remote button.
15. The ARM and AWAY LEDs flash simultaneously, and the READY and POWER LEDs flash
simultaneously.
16. Release the remote button.
17. The ARM and AWAY LEDs flash simultaneously, and the READY and POWER LEDs flash
simultaneously.
18. Press the [*] key to return to steps 11-18 if you wish to add more remotes.
19. Once you have finished, press the [#] key to exit programming.
NOTE:
If you were unsuccessful, the READY and ARM LEDs flash simultaneously, and the AWAY and

POWER LEDs will flash simultaneously. The keypad will beep 3 times and then repeat the beeps.
If the procedure did fail, the menu will retain the setup information and will retry training upon a
press of the [*] key.
A single user code cannot be assigned to multiple Remote Transmitters. Specifically, for every

new Remote Transmitter used with the same code there must be a new Remote Receiver.
Only if a user code is set as a global code will it simultaneously arm/disarm all partitions

assigned to that user code using the Remote Transmitter. A user code can be set as a global
code using Option 10 (User Code Properties) in the User Program Menu. See the X64 User
Manual.
2.6 Add Remote to Panel – Advanced
Use the following steps to add Remote Transmitters to the Remote Receiver connected to an IDS Alarm
Panel via the keypad Bus using the management button.
[*] [Master Code] [*] [2] [1] [*] [Receiver Number] [*] [User Code] [*] [Management Button] [*]
LCD Keypad
1. Hold the [*] key until the beep (3-4 seconds).
2. The keypad displays "Master Code + *".
3. Enter [MASTER CODE] followed by the [*] key.
4. The keypad displays "Option Menu", "Add User Code".
5. Enter [2] [1] followed by the [*] key.
6. The keypad displays "Receiver Num + *".
7. Enter [RECEIVER NUMBER], which could be 1, 2, 3, or 4, followed by the [*] key.
8. The keypad displays "Receiver Receivr N", "Add Code 0000".
9. Enter [USER CODE] followed by the [*] key.
10. The keypad displays "Button*".
11. Enter [MANAGEMENT BUTTON], which could be 0, 1, 2, 3, 4, followed by the [*] key.
12. The keypad displays "Remote Receivr N", "C UUUU M B".
13. Press the [*] key to proceed, or the [#] key to abort.
14. The keypad displays "Press and Hold", "Remote Button".
15. Press and hold the remote button.
16. The keypad displays "...Confirming...".
17. Release the remote button
10
[*] [Press RT Button] [#]
IDS X64 Remote Receiver 700-408-02A Issued August 2010