Installation And Operation; Installation; Ac Adapter Installation; Interface Cable And Cash Drawer Cable Installation - Samsung SRP-275 Service Manual

2. Installation and Operation

2-1 Installation

2-1-1 AC Adapter Installation

Power cord
CAUTION
Before connecting the printer to the power supply, make sure that the voltage and power specifications
match the printer's requirements. Using an incorrect power supply can cause serious damage to the
printer.

2-1-2 Interface cable and Cash Drawer cable Installation

Drawer kick-out connector
Drawer kick-out
cable
NOTES
Connect the printer to the host ECR (host computer) though an interface cable matching the specification
of the printer and the host ECR (host computer). Be sure to use a drawer that matches the printer's
specification.
Depending on the interface your system uses, either connect the serial, parallel, USB or Ethernet
communication cable to the appropriate connector on the back of the printer. Cables are provided by your
dealer or system installer.
Rev. 2.00
AC adaptor
Power connector
Interface
connector
Serial/ Parallel/ USB/ Ethernet
Interface cable
1) Make sure the printer is turned off.
2) Before inserting the AC adaptor, connect the
power cord.
3) Insert the AC adaptor as shown.
4) Plug the AC adapter cable into the printer's power
connector.
5) Plug the power cord into the outlet, and turn on the
power.
1) Turn off printer and the host ECR (host computer).
2) Plug the interface cable into the interface
connector on the printer then fasten the screw on
both sides of the connector.
3) Plug the drawer kick-out cable into the drawer kick-
out connector on the printer.
(When removing the drawer kick-out cable, press
on the connector's clip while pulling out.)
- 9 -
SRP-275