Startup And Initialization Of Srx Controller - Sony SRX-R320 Installation Manual

2-1-3. Startup and Initialization of SRX Controller

Procedure
1. Connect each equipment according to Section 2-1-2.
2. Turn on the power switch on the rear of this unit so that it enters the standby state.
(Refer to step 1 of "2-1-4. Startup of This Unit".)
3. Double-click "Start SRX Controller.exe" on the desktop window.
4. Click the "COM" radio button from the "Connection" menu.
. COM selection: Enter the COM port No. to be used.
5. Select the adjustment menu (Login) to be used in a "Login" menu. The three adjustment menus
below are available.
. User:
Can check the signal input to this unit or adjust an image.
. Maintenance:
Can set a lamp or adjust an image in details.
. Installer:
Can check and change the contents of setting during installation of login informa-
tion or a network.
6. Enter the passwords and click the [OK] button.
. User:
A password is not required.
. Maintenance:
service
. Installation:
setting
n
Enter the passwords of "Maintenance" and "Installer" using lower-case characters.
Click this radio button.
Select "User", "Maintenance"
or "Installer".
SRX-R320
Enter the COM
port No. to be used.
Enter the password.
[OK] button
Fig. 2-1-3a
2-5