Upgrading Through Lan - GE Digi-4 Installation Manual

Upgrading through LAN

To upgrade the firmware through the LAN connection, do the
following:
CAUTION
CAUTION
1. Download the upgrade package onto your PC. To obtain
the upgraded firmware, contact Technical Support.
2. Unzip the upgrade package to a directory.
3. Make sure that your PC and the Digia are both connected
to the same LAN.
4. Select Network Upgrade in engineering mode.
5. On your PC, open the command console by selecting
Start | Run, and typing CMD. Then click OK.
6. In the command console, go to the directory where you
unzipped the upgrade package by typing CD\temp, where
temp is the directory the files are located.
7. At the command line, type the following:
ntmon <IP_address>
...where <IP address> is the IP address of the
Digia set in the Network menu. Once you enter this
command, the system will respond with:
Connecting [<IP Address>]
Connected to [<IP Address>)]
Welcome to TM Monitor Program
8. At the command line, type the following:
up <app.bin>
Refer to the upgrade package release notes for any
updates or changes to this upgrade procedure.
39