Record Menu - GE Digi-4 Installation Manual

Record menu

The second submenu is the Record menu (Figure 5 on page 12).
Navigate through the menu items by pressing the Up and Down
buttons. You can change the value of a menu item by pressing the
Left and Right buttons.
Table 5. Record menu options
Item
Resolution
Channel
Frame rate
Quality
Recording
Motion zone
Motion sensitivity
Sensor type
Pre record
Description
Set resolution to either full or quad.
Select the channel to apply the following settings
to.
Set the frame rate for the specified channel. The
sum of the frame rates from each channel cannot
exceed maximum frame rates for quad (120 fps
for NTSC, 100 fps for PAL) or full (30 fps for NTSC,
25 fps for PAL).
Select the recording quality for the channel from
normal, high, or super.
Assign the method of recording for each channel.
Choose from disable, continuous, by motion, by
sensor, or by schedule.
Select full zone or partial zone.
Set the motion sensitivity for the specified
channel.
Set the type of sensor for the specified channel
from none, N/O (normally open), and N/C
(normally closed)).
Enable or disable preevent recording. The default
time is 5 seconds.
11