Upgrading Firmware - GE Digi-4 Installation Manual

36 Digia
Installation Manual

Upgrading firmware

Digia is designed to be upgradable through firmware updates. To
upgrade the firmware, the Digia must be in engineering mode.
CAUTION
CAUTION
To start engineering mode, do the following:
1. Press the Setup button and enter the admin password
(default is 1111).
2. Go to the System menu and select the Admin password
menu item.
3. Enter the password as 12341234, and press the SEL
button.
Note: To exit engineering mode, regardless if you've upgraded or not,
select Boot Application.
When in engineering mode (Figure 19 on page 37), you can
select the method to use when upgrading. The two methods
available are a USB Upgrade and Network Upgrade.
Note: There are menu items described as test modes. These tests are
used for manufacturing purposes only.
Upgrade procedures may change between releases of
firmware updates. Refer to the release notes included
with each firmware update before proceeding with the
upgrade process.