Table of Contents
Advertisement
• Do not operate charger with damaged cord or plug.
• Do not operate charger if it has received a sharp blow, been dropped, or
otherwise damaged in any way. Take it to an authorized service center.
• Do not disassemble charger; take it to an authorized service center when
service or repair is required. Incorrect reassembly may result in a risk of
electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting any cleaning. This
will reduce the risk of electric shock. Removing the battery pack will not reduce
this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 230 V household electrical
power. Do not attempt to use it on any other voltage. This does not apply to the
vehicular charger.
Chargers
Your tool uses a D
WALT charger. Be sure to read all safety instructions before using
E
your charger. Consult the chart on the back cover of this manual for compatibility of
chargers and battery packs.
FIG. 1
C
Charging Procedure (Fig. 1)
1. Plug the charger into an appropriate outlet before inserting battery pack.
N
5
2. Insert the battery pack (C) into the charger, as shown in Figure 1, making sure
the pack is fully seated in charger. The red (charging) light will blink continuously
indicating that the charging process has started.
3. The completion of charge will be indicated by the red light remaining ON
continuously. The pack is fully charged and may be used at this time or left in the
charger.
Indicator Light Operation
Charge Indicators
Some chargers are designed to detect certain problems that can arise with battery
packs. Problems are indicated by the red light flashing at a fast rate. If this occurs,
re-insert battery pack into the charger. If the problem persists, try a different battery
pack to determine if the charger is OK. If the new pack charges correctly, then the
original pack is defective and should be returned to a service center or other collection
site for recycling. If the new battery pack elicits the same trouble indication as the
original, have the charger tested at an authorized service center.
HOT/COLD PACK DELAY
Some chargers have a Hot/Cold Pack Delay feature: when the charger detects a
battery that is hot, it automatically starts a Hot Pack Delay, suspending charging
until the battery has cooled. After the battery has cooled, the charger automatically
switches to the Pack Charging mode. This feature ensures maximum battery life. The
red light flashes long, then short while in the Hot/Cold Pack Delay mode.
LEAVING THE BATTERY PACK IN THE CHARGER
The charger and battery pack can be left connected with the red light glowing
indefinitely. The charger will keep the battery pack fresh and fully charged.
NOTE: A battery pack will slowly lose its charge when kept out of the charger. If the
battery pack has not been kept on maintenance charge, it may need to be recharged
Advertisement
Table of Contents
