Assembly And Adjustments; Operation - DeWalt DCT414-XE Instruction Manual

FIG. 3
E
F
A
Hold – will display when you have release the trigger to let you know that was
the last temperature read
Scan – will display when you hold the trigger down looking for differing
temperatures
Alarm setting - this icon will let you know what alarm you have chosen to
display; color indicator, beep or both.
F or C – Indicates units of measure for temperature
Battery – will indicate how much charge is remaining on the battery.
NOTE: The low battery indicator is located directly above the temperature reading
on the screen. The bars on low battery indicator will indicate the strength of the
battery. The IR Thermometer may continue to operate for a short time while the
batteries continue to drain, but the beams will quickly dim. After fresh batteries
are installed, and the IR Thermometer is turned on again, the IR Thermometer will
return to its full brightness.
M
G
L
H
K
I
J
INTENDED USE
The IR Thermometer measures surface temperatures by measuring the amount
of infrared emitted off the object. This type of measurement is a non-contact
measurement of the surfaces temperature. This tool comes fully assembled. This tool
has been designed with features that allow for quick and easy set-up.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or removing/installing
attachments or accessories.
Belt Hook (Fig. 2) (Optional Accessory)
WARNING: To reduce the risk of serious personal injury, DO NOT suspend tool
overhead or suspend objects from the belt hook. ONLY hang tool's belt hook from a
work belt.
WARNING: To reduce the risk of serious personal injury, ensure the screw (P)
holding the belt hook is secure.
IMPORTANT: When attaching or removing the belt hook, use only the screw (P) that
is provided.
The belt hook (O) can be be attached to either side of the tool using only the screw
(P) provided, to accommodate left- or right- handed users. If the hook is not desired
at all, it can be removed from the tool.
To move belt hook, remove the screw (P) that holds the belt hook in place then
reassemble on the opposite side.

OPERATION

WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or removing/installing
attachments or accessories.
8