Table of Contents
Advertisement
Installing and Removing the Battery Pack (Fig. 4)
NOTE: Make sure your battery pack is fully charged.
To install the battery pack (C) into the tool handle, align the battery with the rails
inside the tool's handle and slide it firmly into the handle until you hear the lock snap
into place.
FIG. 4
B
C
To remove the battery pack from the tool, press the release button (B) and firmly pull
the battery pack out of the tool handle. Insert it into the charger as described in the
charger section of this manual.
Select Operating Mode
Read the following steps before operating the IR thermometer.
CHOOSE UNITS OF MEASUREMENT
Turn the unit on by engaging the trigger. Once the screen comes on push the C/F
button until the units of measurement is on the correct setting for the application.
CHOOSE EMISSIVITY
Turn the unit on by engaging the trigger, once the screen comes on push the EMS
button for emissivity adjustment. When then EMS is flashing on the screen, use the
up or down arrow buttons to choose the emissivity. Please refer to the chart in order
to choose the correct emissivity. Remember, emissivity adjusts in 0.01 increments.
NOMINAL EMISSIVITY MANUAL
MATERIAL
VALUE
Default****
0.95
Aluminum*
0.30
Asbestos
0.95
Asphalt
0.95
Brass*
0.50
Ceramic
0.95
Concrete
0.95
Copper*
0.60
Glass (plate)
0.85
Iron*
0.70
*
Oxidized
**
Opaque, over 20 mils
*** Natural
**** Factory Setting
CHOOSE ALARM SETTINGS AND HIGH/LOW TEMPERATURES
1. Engage the trigger to turn the unit.
2. Push the ALM button.
3. When the ALM is flashing on the screen use the up and down arrows to select
the alarm type.
Alarm 1 – temperature has reached the set limit, indicated by the red/blue
LED (M)
Alarm 2 – temperature has reached the set limit, indicated by a beeper sound
Alarm 3 – temperature has reached the set limit, indicated by both the LED and
the beeper
4. Push the ALM button again to confirm selection.
5. The HAL (high alarm) will now flash. Use the up and down arrows to select
the high temperature limit. When the temperature is exceeded, the alarm will
activate.
9
MATERIAL
VALUE
Lead*
0.50
Oil
0.94
Paint
0.93
Plastic**
0.95
Rubber
0.95
Sand
0.90
Steel*
0.80
Water
0.93
Wood***
0.94
Advertisement
Table of Contents
