Record - Bosch CCS 800 Ultro Installation And Operating Manual

CCS 800 Ultro | Installation and Operating Manual

7.4 Record

Use the record mode to record discussion. Before
recording, make sure the SD card is inserted into the
slot to the right of the display, or the unit is set to
internal recording.
7.4.1 Overview of record icons
The following icons are displayed/used during
recording.
table 7.3: Overview of record icons
Icon Icon name
Record
selected
Record
Pause
Stop
New file
Change
card
Change
card timer
Hourglass
SD Card
status
Bosch Security Systems B.V. | 2007-08
Function of icon
Shows the user that the Record mode is selected.
Starts recording session.
Pauses recording session. When recording has been paused, the record icon will
appear and start to flash. Press the record button to reactivate recording.
Stops recording session
Creates a new file during recording (recording continues, but the data is saved
under a new file name. The time counter on the display is also reset).
Allows the user to change the SD card during recording (see section 7.4.3).
Graphically shows the user how many seconds are remaining before the new card
must be inserted.
Icon will flash at 2Hz when the SD card is being initialized. During the initialization all
control buttons are disabled.
Card flashing at 2 Hz: card is missing.
Card flashing at 5 Hz: card is either full, write protected, or incompatible.
Note: This icon is not shown during the card exchange procedure or when the
internal memory option is selected in the set-up mode.
If during the card exchange procedure a card is not inserted within one minute of
pressing the change card button, this icon will appear.
en | 22