Connecting An Equalizer; Mains Connection; Connecting A Usb Cable - Bosch CCS 800 Ultro Installation And Operating Manual

CCS 800 Ultro | Installation and Operating Manual
Connect the telephone coupler (2) to the telephone
input and output of the CU (1). The telephone coupler
is further connected to the telephone wall socket (4) and
a telephone (3) for dialing.
A connection to a telephone network must always be
made via a telephone coupler that provides adequate
isolation between the telephone network (PBX) and the
CCS 800 Ultro system. The telephone coupler shall also
meet all relevant requirements for this type of
communication equipment as imposed by law and/or
responsible telecommunication organisations in the
country of use.
Caution
Never try to make a direct connection between
the telephone network and the CCS 800 Ultro
discussion system.

5.9 Connecting an equalizer

1
Recorder
Gain Gain
4
Figure 5.9
Put the insertion switch (3) in position "0" and connect
the cabling (2) of the (mono) equalizer (4) to the
insertion input and output of the CU (1). Switch (3) must
be in position "1" (loop through) if the insertion input/
output is not used.
Bosch Security Systems B.V. | 2007-08
Insertion
Line Telephone
In
Out
3
2

5. 1 0 Mains connection

Trunk in/out Microphone Recorder Line
1
Gain Gain
CCS 800 ULTRO
4 1 5
4
3 2
3
2 3
2
1 4
1
0
3 4
Figure 5. 1 0
Use the supplied mains cord set (5) to connect the CU
(1) to a protective earthed mains socket (2). Press the
on/off switch (3) to power up the system, the display (4)
will be lit.

5. 1 1 Connecting a USB cable

Use the optional USB cable to connect the CU (1) to a
PC. Data can then be downloaded from the CU to the
PC. See section 7 for more information.
Caution
Do not connect the USB cable and audio out-
put/input to the same PC, otherwise the system
will not work.
en | 10
Telephone Insertion
FIELD A
In
2
Digital Acoustic
Out
Feedback Suppression
100-240 V~
5
6 4 6
7 3 7
8 2 8
9 1 9
10 0 10
5