Replacing The Spark Plug - Toro 38614 Operator's Manual

Figure 54
1. Back cover
4. Move the speed selector lever to Position R2.
5. Dip your finger in automotive engine oil and lightly
lubricate hex shaft.
6. Move the speed selector lever to Position 6.
7. Lubricate the other end of the hex shaft.
8. Move the speed selector lever forward and rearward
a few times.
9. Install the back cover and return the machine to the
operating position.

Replacing the Spark Plug

Service Interval: Every 100 hours—Replace the spark
plug.
Use a Champion QC12YC or equivalent spark plug.
Note: To access the spark plug, you must first remove
the upper snow hood (Figure 55).
1. Choke knob
2. Upper snow hood
1. Remove the choke knob and the ignition key
(Figure 55).
2. Remove the 2 screws that secure the upper snow
hood to the machine (Figure 55).
3. Slowly remove the upper snow hood, ensuring that
the primer bulb hose and the ignition wire remain
connected.
4. Remove the bracket thumb screw and the bracket
(Figure 56).
25
Figure 55
3. Ignition key
4. Screw (2)