10-2 Internal Cabling Diagrams
INTERFACE CABLES
This section describes the connections of the interface cables.
Addition of Hard Disk Drive
The connection required when a hard disk drive is added is described below.
Installation of SATA Disks
If the serial ATA (SATA) hard disk drives are added, connect the cables as shown in the figure below.
Fill the drive bay with the hard disk drives from the top to bottom bay.
Power
supply
Mother board
FDD cable
SATA cable (for optical disk drive)
If two or more SATA hard disk drives are connected, you can configure a RAID System by using
the onboard RAID Controller. See Chapter 4 for details.
SATA3
SATA5
SATA1
SATA6
SATA2
SATA4
SATA cable
Optical disk drive
5.25-inch device bay
Floppy disk drive
3.5-inch device bay
First hard disk drive
Second hard disk drive
Third hard disk drive
Fourth hard disk drive