Cub Cadet CC 500 EL Operator's Manual page 17

Blade Installation
1. Place the cutting blade, locking plate, and blade bolt on
the motor shaft and thread the blade bolt in finger tight.
Refer to Fig. 7-1.
NOTE: Make certain to replace the parts in the exact order
in which they were removed. When installing the cutting
blade, be sure it is installed with the curved ends pointing
towards the mower deck and not towards the ground.
2. Torque the blade bolt down using a torque wrench to
assure the bolt is tightened properly. The recommended
torque for the blade bolt is 170-220 in. lbs.
WARNING:
The blade hardware is not only used to
attach the blade assembly, but is also an insulated
safety device and should never be altered in any
way. If replacement is necessary, use original
equipment parts as shown in the parts list.
To insure safe operation of your unit, all nuts and bolts must be
checked periodically for correct tightness.
Off-Season Storage
The following steps should be taken to prepare your lawn mower
for storage.
• Clean and lubricate mower thoroughly as described in the
lubrication instructions.
• We do not recommend the use of a pressure washer or
garden hose to clean your unit.
• Make certain the power supply is disconnected.
• Coat mower's cutting blade with chassis grease to prevent
rusting.
• Store mower in a dry, clean area. Do not store next to
corrosive materials, such as fertilizer.
• Wipe extension cord to remove any foreign substance such
as oil or stains. Replace extension cord if cut or damaged in
any way.
• Wind cord in a series of equal loops on each side of your
hand to prevent snarling.
s 7 — s 17
ectiOn ervice