Samsung SPE-101 User Manual page 26

network connection and setup
Setting up Port Range Forward for several network video encoders
When several network video encoders are connect to one Broadband router device, you
should forward the TCP 943 port of the router to the TCP 943 port of a connected network
video encoder.

J
If you don't set properly the TCP 943 port of the router, you cannot get any video stream from the
web page of the network video encoder.
 TCP 943 port is a port for the Silverlight policy server of a network video encoder.
 You can set a rule of Port Forwarding on the Broadband router device through its
configuration web page.
 You cannot change the Silverlight policy server port of a network video encoder.
 You can change the ports of the network video encoder except the policy server port
through its configuration web pages.
When Network video encoder1 and Network video encoder2 are connected to a router :
User
Start End
943 943
3000 3000
3001 3001
4520 4520
4521 4521
8080 8080
8081 8081
26_ network connection and setup

Internet

Broadband router
Protocol
TCP 192.168.1.100
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101

IP Address

Network Video Encoder 1
(192.168.1.100)
Web Server Port 8080
VNP Port 4520
RTSP Port 3000
Policy Server Port 943
Network Video Encoder 2
(192.168.1.101)
Web Server Port 8081
VNP Port 4521
RTSP Port 3001
Policy Server Port 943