Connecting The Bathroom Speakers - Samsung HG690 Installation Manual

You can connect the Bathroom Speakers using the following method.
¦
Connecting through the Variable Output (available without an external amplifier)
Speaker
Volume Control Box
1. Connect the VARIABLE AUDIO OUT
Speaker +
Speaker -
N/C
2. Connect the VOL-CTRL
The maximum speaker output is 4W, 8 .
The VARIABLE AUDIO OUT
Installing the Volume Control
– If you configure the Volume Control Box as shown in the figure, you can control the volume of the bathroom
speakers.
– The jack that connects the Volume Control Box to the TV is a 3.5mm normal Phone jack.
– Volume Control Box switch is a Tact switch.
Setting the Sub AMP Mode
– 0: Turns the Sub AMP function off (PWM off).
– 1: Determines the Sub volume according to the main volume control. the sub volume is determined according to
the Power On Volume, the Min Volume, and the Max Volume values of Hotel Mode.
– 2: Determines the volume according to the bathroom control panel setting.
Variable Output Port Specifications
– Speaker Wire: Use speaker cable no more than 82 feet (25m) in length.
VOL - UP
VOL - DOWN
( Black /Red 2 )
( White 1 )
14
English
[HG690_EURO]Install_Guide-00ENG.indd 14

Connecting the Bathroom Speakers

1
2
VOL+
VOL-
port of the TV to the Bathroom Wall Speakers of the hotel.
jack of the TV to the Volume Control Box Switch port on the Bathroom Wall of the hotel.
port supports MONO sound out only.
GND
( Shield Wire 3 )
VARIABLE
AUDIO OUT
VOL-CTRL
(HDD 1.0A) (HDD 1.0A)
/ CLONING / CLONING
PC/DVI AUDIO IN PC/DVI AUDIO IN PC/DVI AUDIO IN
HDMI IN 3 HDMI IN 3
HDMI IN 2 HDMI IN 2
( (DVI) (DVI) )
HDMI IN 1 HDMI IN 1
( (ARC) (ARC) )
SATELLITE SATELLITE
AIR/CABLE AIR/CABLE
Volume Control Box
VOL +
1
3
2
VOL -
TV Rear Panel
COMPONENT COMPONENT
/ AV IN / AV IN
PC IN PC IN
2013-03-21 4:36:54