Restarting bridges and repeaters
Associated CLM commands
Setting up bridges using WEPGen
156
11 To check that the connections are working,
go to the wireless status screen in the web
interface or use the CLM
The bridge partners should be shown by
their user-friendly name and listed as Is
Bridging. It may take up to 30 seconds
for the bridge partners to connect.
If one or more of the Nokia A032s is restarted,
bridging information will be temporarily lost.
This may result in loss of communication in the
network for up to 5 minutes until the
information is re-learned from the network.
•
bridge list
associated with the current access point
•
bridge add
new bridge partner to the bridge list
bridge add MAC Name
•
bridge delete
from the current access point
bridge delete MAC Name
You can use the WEPGen utility to specify to
the access point which devices are peer bridges.
See Using the WEPGen utility on page 163.
a command.
show
– shows any bridge partners
– adds the MAC address of a
– deletes a bridge partner
Nokia A032 Advanced User Guide