Table of Contents
Advertisement
1- 120
FEATURES OF YOUR HYUNDAI
NOTE:
Look at a tape before you insert it.
If the tape is loose, tighten it by
turning one of the hubs with a pencil
or your finger.
If the label is peeling off, do not put
it in the drive mechanism.
Do not leave tapes sitting where
they are exposed to hot, warm, or
high humidity, such as on top of
the dashboard or in the player.
If a tape is exposed to extreme heat
or cold, let it reach a moderate tem-
perature before putting it in the
player.
B870D01FC-GAT
ANTENNA
Roof Antenna
B860A03L
Your car uses a roof antenna to receive
both AM and FM broadcast signals.
This antenna is a removable type. To
remove the antenna, turn the antenna
counterclockwise. To install the an-
tenna, turn the antenna clockwise.
!
CAUTION:
o Be sure to remove the antenna
before washing the car in an au-
tomatic car wash or it may be
damaged.
o Before entering a place with a
low height clearance, be sure to
adjust the roof antenna low.
o When reinstalling your antenna,
it is important that it is fully tight-
ened to ensure proper reception.
HTB2043
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Getz and is the answer not in the manual?
Questions and answers
I have a Hyundai Getz 2008 manual. Been in storage out of rego.I Put a new battery light on dash come in but it will not start.
Your 2008 Hyundai Getz may not be starting even after installing a new battery due to an issue with the immobilizer system. The immobilizer light may be flashing five times, indicating a malfunction. A common problem is a faulty connection in the immobilizer ring wiring, specifically the black and white wires leading into the loom. High resistance in the plug can prevent the immobilizer from recognizing the key. A possible fix is to bypass the faulty plug by soldering the wires directly. Additionally, trying to insert and remove the key multiple times or jiggling it slightly may help temporarily.
This answer is automatically generated
Parasitic consume on fuse "POWER CONN & R/LP". I have 0.2 amp consumption on this fuse. I have uninstalled all interior lamps. removed radio, but there is still 0.2 consumption ???? Brand new battery wil die in 2-3 days. Brand new alternator
A 0.2 amp parasitic draw on the "POWER CONN & R/LP" fuse in a Hyundai Getz could be caused by one of the components it protects: the room lamp, audio system, or instrument cluster. Potential causes include:
1. Room Lamp – A faulty or partially stuck switch may keep the lamp circuit active.
2. Audio System – Some audio units retain memory or standby power, but a malfunction could increase current draw.
3. Instrument Cluster – A stuck relay or internal fault in the cluster could cause continuous power consumption.
To diagnose, disconnect each component one at a time and monitor the current draw to identify the source.
This answer is automatically generated