Service - Cub Cadet CC500 BAT Operator's Manual

Service

Blade Care
WARNING:
When removing the cutting blade for
sharpening or replacement, protect your hands with
a pair of heavy gloves or use a heavy rag to hold the
blade. Be certain to disconnect the power supply.
Periodically inspect the blade adapter for cracks, especially if you
strike a foreign object. Replace when necessary. Follow the steps
below for blade service.
1. Stop the motor and remove the safety key.
2. With the battery knob locked or with the battery removed,
turn the mower on its side.
3. Use a block of wood between blade and mower deck to
prevent the blade from turning when the bolt is removed.
4. Loosen and remove the blade bolt, locking plate, and
blade. See Fig. 7-1.
Locking
Block of
Plate
Wood
Figure 7-1
5. The blade can be sharpened with a file or on a grinding
wheel. Do not attempt to sharpen the blade while it is still
on the mower.
Blade Sharpening
To properly sharpen the cutting blades, remove equal amounts
of metal from both ends of the blades along the cutting edges,
parallel to the trailing edge, at a 25° to 30° angle. See Fig. 7-2.
Blade
NOTE: It is important that each cutting blade edge be ground
equally to maintain proper blade balance. The blade can be
tested by balancing it on a round shaft screwdriver. Grind metal
from the heavy side until it balances evenly.
Blade Bolt
Figure 7-2
WARNING:
An unbalanced blade will cause
excessive vibration when rotating at high speeds. It
may cause damage to mower and could break,
causing personal injury.
7
17