Cub Cadet CC500 BAT Operator's Manual page 16

If the overload protection switch pops out shortly after resetting:
1. Release the motor/blade control handle and do NOT restart
the mower for at least 15 minutes to allow the motor extra
time to cool.
2. Press the overload protection switch inward to reset.
3. Restart unit.
NOTE: If the overload protection switch pops out
repeatedly during operation or will not remain in when
attempting to reset, you may need to raise the cutting
height to reduce the strain on the motor or recharge the
battery. If the overload protection switch will not remain in,
contact an authorized service center to arrange for repair.
Replacing Trail Shield
WARNING:
shield is in place and working. Never operate mower
with damaged safety devices. Failure to do so can
result in personal injury.
The trail shield is subject to wear and damage which could
expose moving parts or allow objects to be thrown. For safety
protection, frequently check the trail shield and replace
immediately with original equipment manufacturer's (OEM) part
only.
1. To remove trail shield, lift rear door and remove screws
holding trail shield in place.
16 s 6— M
ectiOn aintenance
Never operate mower unless the trail
& a
djustMents
2. Press shield in on either side to remove from hole. See
Fig. 6-3.
2
Figure 6-3
3. Remove shield from opposite hole and replace with new
shield in the opposite order and manner of removal.
Battery Care
IMPORTANT: Replace with only the identical battery cells
provided with this mower (Part number 925-04381A). The
batteries should only be replaced by an authorized service
dealer.
WARNING:
Due to a potential shock hazard, DO
NOT attempt to remove the motor/battery shroud.
There are no user serviceable parts inside. Contact
your nearest Authorized Service Center if repairs are
needed.
1
2
3